Hazard warning flasher

The hazard warning flasher should be


The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location.

When you must make such an emergency stop, always pull off the road as far as possible.

The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.

To turn the hazard warning lights off, push the switch a second time.

    See also:

    Emergency starting
    Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures listed on page 6- ...

    If the engine will not start
    If engine doesn't turn over or turns over slowly 1. If your car has an automatic transaxle, be sure the gear selector lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check ...

    Vehicle load limit
    Tire and loading information label The tire label located on the driver's door sill gives the original tire size, cold tire pressures recommended for your vehicle, the number of people that ca ...