Engine oil and oil filter


Checking the engine oil level 1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and re-insert it fully.
WARNING - Radiator
hose
Be very careful not to touch the
radiator hose when checking or
adding the engine oil as it may
be hot enough to burn you.
5. Pull the dipstick out again and check the level. The level should be between F and L.


If it is near or at L, add enough oil to bring the level to F. Do not overfill.
For 2.7L gasoline engine, use a funnel to refill the new oil comfortably.
Use only the specified engine oil.
(Refer to "Recommended lubricants
or capacities" in section 8.)
Changing the engine oil and
filter
Have engine oil and filter changed by
an Authorized Kia Dealer according
to the Maintenance Schedule at the
beginning of this section.
See also:
Introduction
How to use this manual
Fuel requirements
Vehicle handling instructions
Vehicle break-in process
Indicator symbols on the instrument cluster ...
Electrical circuit protection
Fuses
A vehicle’s electrical system is protected
from electrical overload damage
by fuses.
This vehicle has two fuse panels,
one located in the driver's side panel
bolster, the other in the ...
Winter driving
Severe weather conditions in the winter
result in greater wear and other problems.
To minimize the problems of winter
driving, you should follow these suggestions:
Snowy or icy conditions
To dr ...


