Hood

Opening the hood


Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly.

2. Go to the front of the vehicle, raise the


2. Go to the front of the vehicle, raise the hood slightly, pull the secondary latch inside of the hood center and lift the hood.

3. Pull out the support rod from the hood.


3. Pull out the support rod from the hood.

4.Hold the hood open with the support rod.

WARNING - Hot parts
Grasp the support rod in the area wrapped in rubber. The rubber will help prevent you from being burned by hot metal when the engine is hot.

Closing the hood
1. Before closing the hood, check the following: • All filler caps in the engine compartment must be correctly installed.

• Gloves, rags or any other combustible material must be removed from the engine compartment.

2. Return the support rod to its clip to prevent it from rattling.

3. Lower the hood until it is about 30 cm (1 ft.) above the closed position and let it drop. Make sure that it locks into place.

WARNING
• Before closing the hood, ensure that all obstructions are removed from the hood opening. Closing the hood with an obstruction present in the hood opening may result in property damage or severe personal injury.

• Do not leave gloves, rags or any other combustible material in the engine compartment. Doing so may cause a heat-induced fire.

WARNING
• Always double check to be sure that the hood is firmly latched before driving away. If it is not latched, the hood could open while the vehicle is being driven, causing total loss of visibility, which might result in an accident.

• The support rod must be inserted completely into the hole provided whenever you inspect the engine compartment. This will prevent the hood from falling and possibly injuring you.

• Do not move the vehicle with the hood raised. The view will be blocked and the hood could fall or get damaged.

    See also:

    Refinement
    The levels of noise, vibration and harshness (NVH) in the Magentis's cabin are particularly low, thanks to a studied programme of measures. These include sound-proofing foam in hollow sections of ...

    Engine oil
    Checking the engine oil level 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minute ...

    Antenna
    Roof type antenna (if equipped) If your vehicle has an audio system, an amplifying antenna is installed in your vehicle. This antenna can be removed from the vehicle when you wash your vehicle. ...