Engine oil
Checking the engine oil level 1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and re-insert it fully.
WARNING - Radiator hose Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.
5. Pull the dipstick out again and check the level. The level should be between F and L.
CAUTION
Do not overfill the engine oil. It may
damage the engine.
If it is near or at L, add enough oil to bring the level to F. Do not overfill.
Use a funnel to help prevent oil from being spilled on engine components.
Use only the specified engine oil. (Refer
to “Recommended lubricants and capacities”
in section 8.)
Changing the engine oil and filter
Have engine oil and filter changed by an
authorized KIA dealer according to the
Maintenance Schedule at the beginning
of this section.
WARNING
Used engine oil may cause skin irritation
or cancer if left in contact
with the skin for prolonged periods
of time. Used engine oil contains
chemicals that have caused cancer
in laboratory animals. Always protect
your skin by washing your
hands thoroughly with soap and
warm water as soon as possible
after handling used oil.
See also:
Normal maintenance schedule
Engine control system
Chassis and body
Chassis and body
Chart symbols:
I - Inspect these items and their related parts. If necessary, correct, clean,
refill, adjust or replace.
R - Replac ...
ISG (Idle Stop & Go) available for three engines
In addition to using the latest technologies to enhance the efficiencies of
each engine, Kia is offering its fuel-stretching ISG (Idle Stop & Go) system -
which automatically switches off and ...
Ignition switch
Ignition switch and anti-theft
steering column lock
Ignition switch position
LOCK
The steering wheel locks to protect
against theft. The ignition key can be
removed only in the LOCK position.
...