Rearview camera
The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position.
This system is a supplemental system that shows behind the vehicle through the rearview display mirror while backing- up unless equipped with a navigation system, then will display on the screen.
The rearview camera may be turned off by pressing the ON/OFF button when the rearview camera is activated.
To turn the camera on again, press the ON/OFF button again when the ignition switch is on and the shift lever in R (Reverse). Also, the camera will turn on automatically whenever the ignition switch is turned off and on again.
WARNING
• This system is a supplementary
function only. It is the responsibility
of the driver to always
check the inside/outside rearview
mirror and the area behind the
vehicle before and while backing
up because there is a dead zone
that can't see through the camera.
• Always keep the camera lens clean. If lens is covered with foreign matter, the camera may not operate normally.
See also:
Knowing your vehicle
Keys
Remote keyless entry
Theft-alarm system
Immobilizer system
Door locks
Windows
Seat
Safety belts
Air bags-supplemental restraint system
Trunk
Hood
Fuel filler lid
Mirrors
Interior lig ...
Hood
Opening the hood:
1. Pull the release lever on the lower
left side of the instrument panel to
unlatch the hood. The hood should
pop open slightly.
2. Go to the front of the vehicle, raise
th ...
If the engine will not start
If engine doesn't turn over or
turns over slowly
1. If your car has an automatic transaxle,
be sure the gear selector lever is in N
(Neutral) or P (Park) and the emergency
brake is set.
2. Check ...