Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location.
When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
See also:
Vehicle load limit
Tire and loading information label
The label located on the driver's door
sill gives the original tire size, cold
tire pressures recommended for your
vehicle, the number of people that
can ...
Towing
If emergency towing is necessary, we
recommend having it done by an authorized
Kia dealer or a commercial tow-truck
service. Proper lifting and towing procedures
are necessary to prevent damage
...
Vehicle certification label
The vehicle certification label attached
on the driver’s side center pillar gives the
vehicle identification number (VIN). ...