Rearview camera
The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position.
This system is a supplemental system that shows behind the vehicle through the rearview display mirror while backing- up.
WARNING
• This system is a supplementary
function only. It is the responsibility
of the driver to always
check the inside/outside rearview
mirror and the area behind the
vehicle before and while backing
up because there is a dead zone
that can't see through the camera.
• Always keep the camera lens clean. If lens is covered with foreign matter, the camera may not operate normally.
See also:
In case of an emergency while driving
If the engine stalls at a crossroad
or crossing
If the engine stalls at a crossroad or
crossing, set the shift lever in the N
(Neutral) position and then push the vehicle
to a safe place.
If you ...
Power steering
Checking the power steering
fluid level
With the vehicle on level ground,
check the fluid level in the power
steering reservoir periodically. The
fluid should be between MAX and
MIN marks on t ...